domodom

Latest articles

• Building and installing u-boot on the mini2440

  21 November 2011, by Dom

  This article explains how to build the u-boot bootloader and download it in the mini2440.

• How to set up a cross compilation toolchain for the mini2440.

  27 October 2011, by Dom

  This article explains how to set up a cross compilation toolchain for the mini2440 with the crosstool-ng tool.

• Installer Ubuntu dans une machine virtuelle sous Windows

  27 October 2011, by Dom

  Cet article montre comment installer Ubuntu sur une machine virtuelle sous Windows.

• How to use the rs232 port (DB9 connector).

  6 October 2010, by Dom

  The COM1 serial port is not working with the Windows CE 6.0 BSP of the mini6410 board. This article explains how to get aroung this problem

• How to start with the mini6410 board

  23 September 2010, by Dom
  The mini6410 can boot from 2 differents mass storage locations, depending on the S2 switch state : its integrated NAND Flash. a SD card (it seems that the max supported size is 2GB, i didn’t try a bigger SD card). We must prepare the SD card if we want that the mini6410 can boot from it by copying on it a bootloader and eventually an operating system. How to prepare the SD card First, if you use a new SD card, you have to format it (FAT32). Then, we have to copy a bootloader on the (...)

• Mini6410 introduction

  22 September 2010, by Dom
  Thanks to the CEO of the www.andahammer.com website who graciously sent me a mini6410, i am able to write some articles about this board. Before to jump into this subject, you can find below a short presentation of this board. The minni6410 is the sister of the mini2440 and has almost the same characteristics with the main following differences : 128MB RAM (64MB for the mini2440). an analog TV out. better placements for the leds end the buttons (on the side of the board instead (...)

• Writing a VB.Net application to drive GPIOs

  3 May 2010, by Dom

  This article shows how to write a VB.Net application that drives the GPIO.

• A GPIO driver for mini2440

  30 April 2010, by Dom

  There is no GPIO driver in the BSP of mini2440, this article explains how I developed my own.

• Sharing folders with Windows CE 6.0 SMB server

  19 March 2010, by Dom

  This article shows how to configure the mini2440 to share folders on network with the SMB server

• A SPI driver for mini2440

  6 March 2010, by Dom

  There is no SPI driver in the BSP of mini2440, this article explains how I developed my own.

0 | 10 | 20